Scan Code Connection to TokenPocket

Scope:

KeyPal 2: Activated, with a wallet already set up on the device (mnemonic created or imported)

TokenPocket: Two scenarios A. Existing wallet (you are already on the Wallet Home) B. No wallet yet (first time use / wallet not created)

Before you start

• Allow TokenPocket camera permission (for scanning QR codes)

• Keep KeyPal 2 screen on and ready on the main interface

• Use a safe environment (avoid others filming your device screen at close range)

A. Connection Steps (TokenPocket with an existing wallet) Entry: Tap “Wallet +” at the top-right of the Wallet Home to enter the hardware wallet section.

Open TokenPocket and go to Wallet Home

Tap “Wallet +” in the top-right corner

Select KeyPal Hardware Wallet

Choose KeyPal 2 → select QR Connect

TokenPocket enters Scan Mode, waiting for the KeyPal 2 dynamic QR code

Now switch to KeyPal 2:

6. On KeyPal 2, go to: Settings / Usage Settings → Connection → TokenPocket

7. KeyPal 2 displays a dynamic QR code (pairing code)

8. Use TokenPocket to scan the QR code on the KeyPal 2 screen

9. After scanning, TokenPocket enters Add/Import Address: follow the prompts to add the network wallet address you need

10. Once done, you’ll see the connected KeyPal 2 address in TokenPocket

B. Connection Steps (TokenPocket with no wallet yet)

On the start page, choose “I already have a wallet”

Enter the KeyPal Hardware Wallet section

Choose KeyPal 2 → select QR Connect

TokenPocket enters Scan Mode

Then follow the same KeyPal 2 steps as in A:

5. KeyPal 2: Settings / Usage Settings → Connection → TokenPocket

6. KeyPal 2 shows the QR code

7. Scan with your phone

8. Add the required network wallet address in TokenPocket

9. Connection complete